logo
Main Page Sitemap

American dj double phase led manual


Service Hours are Monday through Friday 8:00.m.
Also remember that DMX cable must be daisy chained and manual cannot be split.
Voice: (800) 322-6337, fax: (323) 582-2941, e-mail: To purchase parts online visit.The fixture can operate in toyota three different operating modes; show mode, sound-active, or manual controlled via DMX.Do not use the ground lug on the XLR honda connector.Every Double Phase LED has been thoroughly tested and manual has been shipped in perfect operating condition.UC3 Controller, the UC3 controller provides easy-to-use control of avalon various American DJ lighting fixtures.Functions vary with different fixtures.Your cables should be made with a male and female XLR connector on either end of the cable.Operation The Double Phase LED can be controlled via DMX-512 protocol.Mode Selection: Different run modes,.g.Data Cable (DMX Cable) Requirements (For DMX and Master/Slave.The unit can be used as a stand alone unit or linked in a master/slave configuration.Figure 3 1 Ground 1 Ground XLR Male Socket XLR Pin user Configuration 3 Hot 2 Cold 2 Cold 3 Hot XLR Female Socket Pin 3 Data True (positive) Pin 2 Data Compliment (negative) Pin 1 Ground Special Note: Line Termination.The Double Phase LED.DMX data mercury avalon is sent as serial data that travels from fixture to fixture via the data IN and data OUT XLR terminals located on all toyota DMX fixtures (most controllers only have a data OUT terminal).Your unit and your DMX controller require a approved DMX-512 110 Ohm, data cable for data input and data output (Figure 1). . Figure 2 DMX512 IN 3-PIN XLR DMX DMX - common DMX512 OUT 3-PIN XLR Figure 4 rulebook 1 2 3 Termination reduces signal errors and avoids coupe signal transmission problems and interference. .
Introduction: The Double Phase LED is a dual toyota barrel mirrored, DMX intelligent, 4-in-1 rgbw manual LED fixture.
General Information provides a toll free customer.



When longer runs of cable are used, you may need to use a terminator on the last unit to avoid erratic behavior.
A terminator is american dj double phase led manual a 110-120 ohm 1/4 watt resistor which is con- nected between pins 2 and 3 of a male XLR connector (data and data -).
If you are making your own cables, be sure to use stan- dard 110-120 Ohm shielded cable (This cable may be purchased at almost all professional sound and Double Phase LED Set Up Figure 1 lighting stores). .

Sitemap